Please Allow Time For Images To Load

Shed &Workshop security anchorage point 

 

Motorcycles - Jetskis - Tractor mowers - Scooters - Workshop equipment 

 

Other shed fitting security anchors are fitted to the inside of the shed and can easily be levered away from their fixings.

Unlike the rest our shed anchor is designed to fit on the outside with only the anchorage point facing into the shed through a square hole cut into the shed. The reason for this is that the whole anchor would have to be pulled through the shed floor or wall. And once the anchor has a security chain fed through and attached to a motorcycle etc it can't be pulled away in the opposite direction

Floor                                                                       Wall

             

 Floor or wall fitting

The shed anchor can be fitted to either the shed floor or wall.

Floor fitting gives maximum security to mobile objects such as Motorcycles, Ride on mowers, Jetskis etc.

When floor fitting is not practical for example, work shops where the anchor if fitted to the floor may cause an obstruction. Then the shed anchor can be fitted to the shed wall and is ideal security for expensive machinery such as Generators, Compressors, Lathes etc.

 

The offset design enables the anchor to fit close up to the adjacent wall / floor without compromising on surface area.

                                                                                               

                  

 

 

 

Fitting

 

Floor Fitting

   

A:   From inside the shed mark out the hole in the desired position (you can see where the joists are situated by the nails that attach them to the floor)

B:   Cut out the hole using a jigsaw (You may need to raise up the shed slightly for the blade to clear the ground)

C:   Raise the shed enough to slide the shed anchor into position. 

D:   Lower the shed, bolts are not essential as once the anchor has a security chain fed through and attached to a motorcycle etc it can't be pulled out from the floor in either direction

 

    

 

 

 

Wall Fitting

A:   From the inside mark out the hole in the desired position.

B:   Cut out the hole using a jigsaw. Hold the shed anchor in position and drill out the holes for the fixing bolts.

C:   Bolt the shed anchor into position with the nuts on the inside.

(all fixing bolts, nuts, washers supplied).

           

D:  The fixing bolts main purpose is to hold the shed anchor in position. Similar to the floor fitting, once the anchor has a security chain fed through and attached to a motorcycle etc it can't be pulled out from either direction. However as an added precaution when the fixing bolts are fully tightened. The remaining bolt thread can be bent over. 

A copy of these instructions come with the Shed anchor.

  

 

                         

Dimentions

 

            

                                                                                                                           

 

£34.99 plus £7.99 p&p (UK only)

If you would like to purchase the Shed anchor

you can make a secure Pay Pal payment by using the button below.

Please note this button is for UK sales only. 

email for cheque payment details and for multiple orders.